AOpen DE7200 Series Instrukcje Operacyjne Pobierz pdf (Strona 75)

MAINTENANCE

31 Dec 13 5-13

DE-7200VFDCentrifuge

10. Attach a hoist capable of lifting at least 4000 lbs (1800 kg) to rotating assembly.

11. Properly balance the hoisting straps to ensure that the assembly remains horizontal during

lifting, and slowly hoist rotating assembly until clear of base.

12. Lower rotating assembly onto a cradle that is capable of supporting its weight.

Figure 5-6. Bearing Pillow Block

Cleaning and Inspection

1. Wash mud and debris from interior and exterior of bowl assembly, and blow dry with filtered

compressed air. Remove any corrosion to facilitate inspection.

2. Inspect wear inserts for obvious wear. If significant damage is found, replace inserts using Kit

G0009149. To help preserve dynamic balance, inserts are always replaced in pairs that are

opposite to each other.

3. Inspect solid discharge wear inserts and weir plates on head wall of bowl assembly for cracks,

fractures, or other damage, and replace if obviously damaged using Kit G0009149.

4. Inspect bowl exterior for corrosion, excessive wear, or other damage that may affect

performance. Contact Derrick if excessive corrosion or wear is found.

5. Check main bearings for roughness, noise, or rubbing. If bearing damage is found, replace

rotating assembly in accordance with procedures in this section. Return defective rotating

assembly to Derrick for overhaul.

6. Inspect pillow blocks for corrosion, distortion, nicks, cracks, burrs, fractures, or other defects.

Repair any minor defects, or replace if serious defects or cracks are found.

7. Determine wear of conveyor flights as follows:

a. Remove inspection plug from bowl extension, and insert vernier caliper through hole and

into contact with conveyor flight (Figure 5-9).

b. The dimension indicates the radial wear of the flights. For example, a dimension of

24.2mm indicates radial wear of 5mm.

c. If radial wear exceeds 6mm, the rotating assembly should be returned to Derrick for

overhaul.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 166 167

Brak uwag

AOpen DE7200 Series Instrukcje Operacyjne Strona 75